Leslie Speaker type 6W controller - 145, 147, 125, 120, 247 with footswitch

Description

Leslie controller for type 145/147 (6W) cabinets
Also available without a footswitch for less, check my other listings or ask for more details.
No preamp necessary when used with a Hammond Organ, ideal for Hammond's hot output
This box is for 6 pin Leslies with a Leslie 145/147 connector type (6W – also includes 25, 31W, 44W, 46W, 45, 47, 47R, 110, 112, 114, 116, 120, 120C, 125, 225, 145, 147, 147V, 147RV, 245, 247, 247RV)  This controller must NOT be used with 122 (6H type) Leslies.   For those there is a different controller.
For guitar or other keyboards, a simple preamp or mini mixer is needed, there are 100's that will do the job, you probably already have one.   Many of the new Hammond and Nord organs will have a "high level output" along with an 11 pin, either way you can get the signal there.   Got questions about what you need, feel free to ask I'll help you figure out the best thing to do for your system.
This unit replaces the 6147 kit at half the price, with improved, safer, low voltage DC speed switching.    As you may know current UL standards don't even allow the AC voltage going to the switch, that's why later models, and all modern Leslies have 11 pins.
Feel free to ask questions through the ebay system, but please be sure all messages start with telling me exactly which Leslie you are using or hope to use, and what you intend to plug into it, but read on and your questions may be answered.
This box is a very economical improvement over the vintage Leslie Combo-Preamp Boxes that go for much more money.
A combo/preamp is a preamp and controller, that's the "combo" two things in one.   This is a controller that is free standing, that you don't have to cobble into your organ and that can be used with many things.    It uses 1/4 inch inputs to make hook up and switch overs easier.   If you are going from an organ to a preamp a combo-preamp is the wrong thing, because the organ and speaker are already perfectly matched in level and the boost of the preamp will create a brittleness and distortion to the sound.    If you are going from a non-Hammond instrument it will need a preamp.
Also this unit has a separate switch input which makes it easier to put the switch in a convenient place, or you can use your own favorite half moon or pedal mount kick switch, and it sends 5v DC to the switch instead of 120v AC, greatly reducing the shock hazzard of the older units.    This means no dangerous AC voltage at your feet or on a switch with your hand on it, and no "vintage" shocking accidents that were common in the 70's.   It's (-5v DC) current is safe enough to go through snakes and patchbays.
For a preamp I highly recommend the ART tube MP, which you can find here on ebay for about -.
The main problem with the vintage combo preamp boxes is the preamp in them isn’t that special, especially for guitar.    It works, but it can sound better.    If you have a vintage tube amp with a preamp out, then this is for you.    I also recommend the ART tube MP, they’re very affordable, and very versatile.
You can easily take a direct out from a 1/4 inch on an A-100 or M-3, or most any other other low watt amp, the 147/145 type Leslies were built with a "console resistor" control, so that the Leslie can work from the organ's output as a booster amp.
Leslies have NO AC ground, just two leads of AC power on pins 3 and 4, therefore, it's very important to keep your Leslie isolated, which this unit does by using a very low voltage (-5v DC) DC relay.    Other controllers that have a third prong do not ground your Leslie, because that ground can't go to the Leslie on the 6 pin cable, the safest way is to use a relay to control the Leslie's own high voltage AC system.
I am also selling this box in a set with a footswitch for 9, send a message you need the switch too.
Custom orders are possible, and usually cost the same as the pre-made boxes.    Need a box for a different Leslie? Need to run two Leslies?   Two different Leslies?    Whatever the situation, Let me know, I can probably help out.
There are demos on YouTube, but eBay doesn't let me post them here, so go have a look.
Thanks for your interest!
Why Fishsticks?!?
Um... There are a few reasons. I have a 1984 Mercedes diesel that I converted to run on waste veggie oil, that kinds smells like fishsticks, so I first named that Dr. Fishsticks. I wanted to choose a name for these controllers that would let you know that I'm not one of those way to uptight, grumpy, Hammond organ guys, that I am a guy in my converted garage workshop making this stuff for you. I don't have a clear coat on my online presence pretending to be a big operation, I'm a one-man operation, and proud of it. I am a piano technician, a tube amp and Hammond/Leslie repair man, and a player, and have been for 15 years.   Also, I like fishsticks.